Nsi-industries EH20B Bedienungsanleitung PDF herunterladen (Seite 9)

8.0 NOTES:

1. MAN mode: Under this mode the unit disregards

the settings in the schedule mode and remains

in its manually set status ON or OFF. NOTE: To

resume regular schedule execution press the

mode key to return to AUTO mode.

2. Unit will go to RUN MODE automatically (except

on the MAN mode) if no key is pressed for five

minutes.

3. Clear all memory. All memory can be cleared

using the following procedure: While in the RUN

mode, press ENTER, display will show:

Use EVENT key to display:

Now press ENTER briefly and everything in the

timer memory will be erased, including real time

and date. NOTE: Unit has permanent memory

and will not be erased unless done through pro-

cedure above.

4. Upon powering up your EH10B/EH20B the dis-

play will show at what frequency the unit is oper-

ating, 50 will determine 50Hz or 60 for 60Hz.

NOTE: While in the AUTO mode, if AC power is

absent, the display will show a PF (power failure)

instead of the seconds scrolling up.

5. A “Lo” on the display indicates that the super cap

has run low and the unit needs to be powered

with AC. A minimum of 8 hours is required to fully

charge the super cap.

OFF

CLK DATE SCH AUTO MAN

OFF

CLK DATE SCH AUTO MAN

EH10_20B single 7/24/07 11:10 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Nsi-industries EH20B Bedienungsanleitung Seite 9