Nsi-industries DGUM-A Series Bedienungsanleitung PDF herunterladen (Seite 13)

9.0 REVIEW, MODIFY AND DELETE

Press MODE to advance to any of the following

MODES:

1. AUTO MODE: In this automatic mode, the unit will

execute the scheduled programs. Time, day, seconds

and load status are displayed. If today is a

programmed holiday, the day of the week will ﬂash.

OVERRIDE IN AUTO MODE: The load status of the

channel can be manually changed by pressing the

OVRD key (or OVR1 and OVR2 key for two channel

units).

The unit will stay in this position until the next

scheduled event. A ﬂashing LCD load indication (ON,

OFF) shows the status was changed by the override

not a scheduled event.

Note: To force the circuit ON when an EPC-A photo

sensor installed, you must cover the photo sensor and

place the override into the ON position.

2. MAN MODE: In this manual mode, the unit will

ignore the schedule programs. Time, day, seconds

and load status are displayed. If today is a

programmed holiday, the day of the week will ﬂash.

This can be used as a VACATION SETTING to keep

load off while away. Use override to set to OFF

position.

OVERRIDE IN MAN MODE: The load status of the

channel can be manually changed by pressing the

OVRD key (or OVR1 and OVR2 key for two channel

units).

The unit will stay in this position until OVRD is pressed

again. A ﬂashing LCD load indication (ON, OFF)

shows the status was changed by the override not a

scheduled event.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Keine Kommentare

Nsi-industries DGUM-A Series Bedienungsanleitung Seite 13